you can probably look for the instrument panel controller and operate the light manually to make sure it turns on and off. If you want to post the results of an auto-scan, go advanced, and with the scan output pasted into the window and with the body of text selected, push the button. Code: Like this.
Lær på under 1 min at nulstille din blinkende DPF og spar penge på værkstedsbesøg. Jeg har prøvet det 3 gange nu og jeg har ikke kunnet mærke forskel på bile
First time - P243C dpf regen frequency, P117a engine oil over temp - oil level slightly high, checked PIDs - pm acc to high - injection correction done, checked boost pressure sensor - ok, carried out pdf regen -- suvvessful PIDs within spec, replaced oil, reset oil data - all ok.
aust_norm said: They checked it out and apparently there is a bulletin out from Subaru Australia advising of the issue which is someting called " oil dilution ". The fix is to drain the oil (I assume it was engine oil) and reset the DPF sensor. All up a 15 to 20 minute job that was done for free. Norm.
Repair steps: Connect the DrivePro device and then read out the DTC for the engine. If the code P1336 is set and the DPF light is flashing while the engine is running, you should check timing chain as described below. Next, remove the valve cover. Once this has been removed, the timing chain, camshaft gears and valve train will be exposed.
I only joined the forum to post this ! If the DPF light is flashing it is probably because it wasn't reset at your last service. Most common reason for flashing DPF is that it is the "Service overdue indicator".
Next morning set off for work and after half a mile, DPF light came on flashing, shortly followed by check engine light and car went into limp mode. Drove straight to Mazda and they diagnosed fault code p2002 (DPF efficiency below threshold).
XJCh. h0jw55n6ay.pages.dev/488h0jw55n6ay.pages.dev/451h0jw55n6ay.pages.dev/428h0jw55n6ay.pages.dev/331h0jw55n6ay.pages.dev/208h0jw55n6ay.pages.dev/80h0jw55n6ay.pages.dev/314h0jw55n6ay.pages.dev/486
mazda 6 dpf light flashing reset